Network Working Group B. Fox
Request for Comments: 2685 Lucent Technologies
Category: Standards Track B. Gleeson
Nortel Networks
September 1999
Virtual Private Networks Identifier
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1999). All Rights Reserved.
Abstract
Virtual Private IP networks may span multiple Autonomous Systems or
Service Providers. There is a requirement for the use of a globally
unique VPN identifier in order to be able to refer to a particular
VPN (see section 6.1.1 of [1]). This document proposes a format for
a globally unique VPN identifier.
1. Introduction
As the Public Internet expands and extends its infrastructure
globally, the determination to exploit this infrastructure has led to
widespread interest in IP based Virtual Private Networks. A VPN
emulates a private IP network over public or shared infrastructures.
Virtual Private Networks provide advantages to both the Service
Provider and its customers. For its customers, a VPN can extend the
IP capabilities of a corporate site to remote offices and/or users
with intranet, extranet, and dialup services. This connectivity
should be achieved at a lower cost to the customer with savings in
capital equipment, operations, and services. The Service Provider
is able to make better use of its infrastructure and network
administration expertise offering IP VPN connectivity and/or services
to its customers.
There are many ways in which IP VPN services may be implemented. The
IP based VPN framework document [1] identifies four types of VPN to
be supported: Virtual Leased Lines, Virtual Private Routed Networks,
Fox & Gleeson Standards Track [Page 1]
RFC 2685 Virtual Private Networks Identifier September 1999 Virtual Private Dial Networks, and Virtual Private LAN Segments. In addition, numerous drafts and white papers outline methods to be used by Service Providers and/or Service Provider customers to enable this service. Solutions may be customer based or network based. Network based solutions may provide connectivity and services at layer 2 and/or layer 3. The devices involved in enabling the solution may be Customer Premises Equipment (CPE), Service Provider Edge equipment, Service Provider Core equipment, or some combination of these. While the various methods of VPN service implementation are being discussed and debated, there are two points on which there is agreement: Because a VPN is private, it may use a private address space which may overlap with the address space of another VPN or the Public Internet. A VPN may span multiple IP Autonomous Systems (AS) or Service Providers. The first point indicates that an IP address only has meaning within the VPN in which it exists. For this reason, it is necessary to identify the VPN in which a particular IP address has meaning, the "scope" of the IP address. The second point indicates that several methods of VPN service implementation may be used to provide connectivity and services to a single VPN. Different service providers may employ different strategies based on their infrastructure and expertise. It is desirable to be able to identify any particular VPN at any layer and at any location in which it exists using the same VPN identifier. 2. Global VPN Identifier The purpose of a VPN-ID is to identify a VPN. This identifier may be used in various ways depending on the method of VPN service implementation. For example, the VPN-ID may be included: - In a MIB to configure attributes to a VPN, or to assign a physical or logical access interface to a particular VPN. - In a control or data packet, to identify the "scope" of a private IP address and the VPN to which the data belongs. It is necessary to be able to identify the VPN with which a data packet is associated. The VPN-ID may be used to make this association, either explicitly (e.g. through inclusion of the VPN-ID in an encapsulation header [2]) or implicitly (e.g. through inclusion Fox & Gleeson Standards Track [Page 2]
RFC 2685 Virtual Private Networks Identifier September 1999 of the VPN-ID in a ATM signalling exchange [3]). The appropriateness of using the VPN-ID in other contexts needs to be carefully evaluated. There is another very important function that may be served by the VPN identifier. The VPN identifier may be used to define the "VPN authority" who is responsible for coordinating the connectivity and services employed by that VPN. The VPN authority may be the Private Network administrator or the primary Service Provider. The VPN authority will administer and serve as the main point of contact for the VPN. The authority may outsource some functions and connectivity, set up contractual agreements with the different Service Providers involved, and coordinate configuration, performance, and fault management. These functions require a VPN that is global in scope and usable in various solutions. To be a truly global VPN identifier, the format cannot force assumptions about the shared network(s). Conversely, the format should not be defined in such a way as to prohibit use of features of the shared network. It is necessary to note that the same VPN may be identified at different layers of the same shared network, e.g. ATM and IP layers. The same VPN-ID format and value should apply at both layers. The methods of VPN-ID usage are beyond the scope of this memo. 3. Global VPN Identifier Format Requirements The VPN Identifier format should meet the following requirements: - Provide a globally unique VPN Identifier usable across multiple Service Providers. - Enable support of a non-IP dependent VPN-ID for use in layer 2 VPNs. - Identify the VPN Authority within the VPN Identifier. 4. Global VPN Identifier Format The global VPN Identifier format is: 3 octet VPN authority Organizationally Unique Identifier [4] followed by 4 octet VPN index identifying VPN according to OUI Fox & Gleeson Standards Track [Page 3]
RFC 2685 Virtual Private Networks Identifier September 1999 0 1 2 3 4 5 6 7 8 +-+-+-+-+-+-+-+-+ | VPN OUI (MSB) | +-+-+-+-+-+-+-+-+ | VPN OUI | +-+-+-+-+-+-+-+-+ | VPN OUI (LSB) | +-+-+-+-+-+-+-+-+ |VPN Index (MSB)| +-+-+-+-+-+-+-+-+ | VPN Index | +-+-+-+-+-+-+-+-+ | VPN Index | +-+-+-+-+-+-+-+-+ |VPN Index (LSB)| +-+-+-+-+-+-+-+-+ The VPN OUI (IEEE 802-1990 Organizationally Unique Identifier) [4] identifies the VPN authority. The VPN authority will serve as the primary VPN administrator. The VPN authority may be the company/organization to which the VPN belongs or a Service Provider that provides the underlying infrastructure using its own and/or other providers' shared networks. The 4 octet VPN Index identifies a particular VPN serviced by the VPN authority. 5. Security Considerations This document defines the format of the global VPN identifier without specifying usage. However, the association of particular characteristics and capabilities with a VPN identifier necessitates use of standard security procedures with any specified usage. Misconfiguration or deliberate forging of VPN identifier may result different breaches in security including the interconnection of different VPNs. 6. References [1] Gleeson, Heinanen, Lin, Armitage, Malis, "A Framework for IP Based Virtual Private Networks", Work in Progress. [2] Grossman, D. and J. Heinanen, "Multiprotocol Encapsulation over ATM Adaptation Layer 5", RFC 2684, September 1999. [3] "MPOA v1.1 Addendum on VPN Support", ATM Forum, af-mpoa-0129.000, August, 1999, Bernhard Petri, editor, final ballot document. [4] http://standards.ieee.org/regauth/oui/index.html Fox & Gleeson Standards Track [Page 4]
RFC 2685 Virtual Private Networks Identifier September 1999 7. Authors' Addresses Barbara A. Fox Lucent Technologies 300 Baker Ave, Suite 100 Concord, MA 01742-2168 Phone: +1-978-287-2843 EMail: barbarafox@lucent.com Bryan Gleeson Nortel Networks 4500 Great America Parkway, Santa Clara, CA 95054 Phone: +1-408-855-3711 EMail: bgleeson@shastanets.com Fox & Gleeson Standards Track [Page 5]
RFC 2685 Virtual Private Networks Identifier September 1999 8. Full Copyright Statement Copyright (C) The Internet Society (1999). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Fox & Gleeson Standards Track [Page 6]
mirror server hosted at Truenetwork, Russian Federation.